Dimplex DF2426GB - Manual (Page 9)

minimum of 1875 watts.
Option #3 - Hardwire
1. Wire a dedicated, properly fused circuit with 120 Volt,
15 Amp
rating. Allow up to 8 feet of service cable for connecting power
supply to junction box on fireplace when installing after finishing
wall.
CAUTION: Use two conductor, non-metallic sheath cable with
ground wire (3 wires total) for the incoming power supply on
fireplace inserts. Use appropriate wire to meet local and
national electrical codes for rated power consumption.
2. Remove the outer jacket and strip the individual conductor from
the end.
3. Loosen the screw securing the junction box cover and remove
the cover.
4. Take the cables out from the junction box, loosen the two wire
twist nuts and remove the cord set. (Figure 3)
6
Figure 3 Figure 4
5. Route the power supply wire through the knockout on supplied
alternative junction box cover and secure with a wire clamp (not
supplied). (Figure 4)
6. Connect the black wire (live) from the unit to the black wire from