Dimplex DF2426GB - Manual (Page 12)

To operate, push the ON button to turn fireplace on, push the OFF
button to turn the fireplace off.
Battery Replacement (FIGURE 6)
To replace the battery:
1. Slide battery cover open
on the hand held
transmitter.
2. Install one 12-Volt (A23)
battery in the battery
holder.
3. Close the battery cover.
Remote Initialization
In the event that your remote
control ceases to operate
your fireplace, follow these
steps to re-initialize the hand-
held transmitter and the remote control receiver in the fireplace:
1. Place the
Main ON/OFF Switch (Figure 5 A) in the OFF (“o”)
position.
2. Wait a minimum of 5 seconds and then place the
Main ON/OFF
Switch in the Remote Control (“=”) position.
3. Within 10 seconds of changing the switch position, press the ON
button located on the remote control transmitter (Figure 6).
This will synchronize the remote control transmitter and the fireplace
receiver.
NOTE: You will have only 10 seconds to perform this last step.
Failure to do so will result in these steps needing to be followed
again.
If you are still experiencing issues with your remote control, contact
Dimplex North America Limited Customer Service at 1-888-346-7539,
or vist the Dimplex website at www.dimplex.com.
9
Figure 6
Off
Button
On
Button
Battery
Battery
Cover
!