Glass cleaning, Fireplace surface cleaning – Dimplex DF2426GB User Manual
Page 14

4. Disconnect flicker from
motor. (See Figure 7)
5. Unscrew bulbs counter
clockwise.
6. Insert new bulbs.
7. Reconnect flicker to
motor.
8. Replace the logset by
inserting the front edge
of the log set and push
down on the rear edge of the ember bed until it snaps into place.
(Figure 8)
NOTE: Ensure the logset is installed tightly under the back ledge to
prevent light leakage.
9. Replace glass assembly.
Glass Cleaning
The front glass is cleaned in the factory during the assembly operation.
During shipment, installation, handling, etc., the front glass may collect
dust particles, these can be removed by dusting lightly with a clean dry
cloth.
To remove fingerprints or other marks, the glass can be cleaned with a
damp cloth. The glass should be completely dried with a lint free cloth
to prevent water spots. To prevent scratching, do not use abrasive
cleaners or spray liquids on the glass surface.
Fireplace Surface Cleaning
To remove fingerprints or other marks, the exterior finish can be
cleaned with a damp cloth with a mild detergent. The surface should
be completely dried with a lint free cloth to prevent water spots
.
11
!
Figure 8
Side Section
Front
Edge
Log Ember
Bed
Back
Ledge
Rear
Tab