Dimplex DF2426GB - Manual (Page 13)

Maintenance
Light Bulb Replacement
Allow at least 5 minutes for light bulbs to cool before touching bulbs to
avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the
flame or when the clarity and detail of the log ember bed exterior
disappears. There are two bulbs under the log set, which generate the
flames and embers.
Light Bulb Requirements
Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small)
socket base, 60 Watt rating. Example: GE 60BC or Philips 60 CTC.
Do not exceed 60 Watts per bulb.
Helpful Hints
It is a good idea to replace both light bulbs at one time if they are
close to the end of their rated life. Group replacement will reduce the
number of times you need to open the unit to replace light bulbs. Care
must be taken when removing the logset.
To Access The Lower Light Bulb Area: (Figure 7)
1. Remove front glass assembly.
2. Pull the back edge of the
plastic ember bed forward
until the rear tab releases
from the ledge located at
the bottom of the mirror.
IMPORTANT: Only handle
the logset by the ember bed.
NOTE: Logset fits tightly
into firebox, some force
may be necessary to
remove.
3. Set logset in front of fireplace.
10
!
Figure 7
Flicker