Dimplex DF2426GB - Manual (Page 11)

Operation (Figure 5)
A. Main ON/OFF Switch
The switch has two ON positions marked. The “ -- “ position is for
manual operation. In this position the built-in remote control is by-
passed. The “ = “ position is for operating the unit with the provided
remote control. When in remote control (“ = “) position the unit is
operated with the ON and OFF buttons of the remote control.
When the switch is in the center “o” position the unit is off.
B. Heater ON Switch
The Heat ON/OFF Switch supplies power to the heater fan and the
heater element. When the switch is in the ON position the heater
operates if the thermostat calls for heat.
C. Heater Thermostat Control
To adjust the temperature to your individual requirements, turn the
thermostat control clockwise all the way to turn on the heater. When
the room reaches the desired temperature, turn the thermostat knob
counter-clockwise until you hear a click. Leave in this position to
maintain the room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will turn on.
Resetting The Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn the fireplace
off and it will not come back on without being reset. It can be reset by
switching the Main ON/OFF switch to OFF and waiting 5 minutes
before switching the unit back on.
CAUTION: If you need to continuously reset the heater, disconnect
power and call Dimplex customer service at 1-888-DIMPLEX
(1-888-346-7539).
Remote Operation
The fireplace is supplied with an integrated on/off remote control
NOTE: Ensure that the fireplace Main ON/OFF switch is set to
the remote control setting.
8
!