Dimplex DF2426GB - Manual (Page 7)

circuit breaker.
WARNING: Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of
fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce
the risk of fire, electric shock or injury to persons, always use a
licensed electrician.
Site Selection And Preparation
This section provides instructions for selecting a location and preparing
the site to install the fireplace into your Dimplex mantel surround.
1. Select a suitable location that is not susceptible to moisture and is
away from drapes, furniture and high traffic.
2. For ease of electrical hook up you may wish to locate the fireplace
near an existing outlet. (Refer to NOTE 1)
3. Store the fireplace in a safe dry and dust free location.
NOTE: The dimensions of the fireplace are 26 inches (660.5 mm)
wide X 18 7/8 inches (479.5 mm) high X 9 1/4 inches (235 mm)
deep. The fireplace does not require any additional venting.
Fireplace Installation
1. Install the fireplace assembly into the mantel. (Refer to mantel
assembly instructions)
NOTE 1: A 15 Amp, 120 Volt circuit is required. A dedicated circuit
is preferred but not essential in all cases. A dedicated circuit will be
required if, after installation, the circuit breaker trips or fuse blows
on a regular basis when the heater is operating.
Additional appliances on the same circuit may exceed the current
rating of the circuit breaker.
4
!
!