Wa kom – Nortec Air Humidification System BS User Manual
Page 11
25.05.05-A
page 11 of 30
10
15
20
20
30
WA
KOM
Trafo1
Trafo2
A
B
4.1.1.2 Determining the device requirements
Now the decisive value of the necessary humidification capacity is available for the determination. The
following notes on the capacity of the atomisers provide a second basis.
Capacity BS10 10 Kg/h (22 lbs/h)
EXAMPLE 1
Total water volume (mH2O) = 46 kg/h (101 lbs/h)
Required:
5 units BS10
2 units transformer (trafo)
The tube requirements for air supply and power supply depend on the cable. They are
determined on the basis of the ground plan. The result for this example is approx. 70 meters
(230 ft) of the NORTEC quick assembly kit (SMB). The SMB comes with the necessary cables,
low-pressure tubes and fittings. For further notes on the tube run, please see Chapter 4.3-4.5.
The solid line stands for power supply, the dotted line for air and water supply.
WA:
Water treatment, if necessary
KOM: Compressor
String
from
A
to
B
Point
of
distribution
IMPORTANT: Take care not to connect more than 6 BS5/10 to one string when planning the
supply network for the atomisers (water and compressed air). Malfunctions may occur if more
than 6 devices are connected. To prevent this and if required, two further strings must be
created for splitting up the string (see sketch above).