Nevion Multicon - Manual (Page 69)

Hardware Information 69
ID: man-multicon Multicon Manual Rev. L
12.10.2 Hardware revision 4
Figure 12.10 Rear-view Mk4
The following service connectors can be found on the rear of the Multicon hardware revision 4:
COM1 - DB9 Male serial port (RS-232/422)
Use this to connect either VikinX routers or third party equipment, using RS-232 or RS-422
control protocols.
COM2 - RJ-45 serial port (RS-232/422)
Use this to connect either VikinX routers or third party equipment, using RS-232 or RS-422
control protocols.
GBE1 - RJ-45 Ethernet (10/100/1000BaseTX)
Use this to connect to an Ethernet switch, using 10/100/1000 Base-T Ethernet protocol.
GBE2 - RJ-45 Ethernet (10/100/1000BaseTX)
Use this to connect to an Ethernet switch, using 10/100/1000 Base-T Ethernet protocol.
GPI IN - KK 5 PIN
Use this to connect GPI inputs.
GPI OUT - KK 5 PIN
Use this to connect GPI outputs.