Nevion Multicon - Manual (Page 68)

Hardware Information 68
ID: man-multicon Multicon Manual Rev. L
12.10 Back Plane Connectors
12.10.1 Hardware revision 2
Figure 12.9 Back plane for controller card
The following service connectors can be found on the rear of the Multicon hardware revision 2:
COM1 (RS-232/422)
Use this to connect either VikinX routers or third party equipment, using RS-232 or RS-422
control protocols.
COM2 (RS-232/422)
Use this to connect either VikinX routers or third party equipment, using RS-232 or RS-422
control protocols.
Ethernet 100BaseTX
Use this to connect to an Ethernet switch, using 10/100Base-T Ethernet protocol.
GPI
RJ45 GPI connector.
COM3 (RS-422)
Use to connect Multicon in an N-BOX to Flashlink Compact or Flashlink frame (external
connectivity when Multicon is not in a Flashlink frame).