Rtk-x tolerance – NavCom LAND-PAK Rev.F User Manual
Page 99
LAND-PAK™ User Guide – Rev. F
5-99
RTK-X Tolerance
The receiver must have attained an RTK fix and have
tracked StarFire Dual mode before an RTK-X position
can be obtained. Both of these caveats normally
occur within 5 minutes of normal RTK operation.
Perform these steps to set the RTK-X (RTK-Extend)
tolerance parameters:
1. Log on to FieldGenius and select a project or
create a new one.
2. On the Instrument Selection dialog box (refer to
Figure 39), select GNSS Rover.
3. Click Edit.
4. On the GNSS Profile dialog box (refer to Figure
53), select Tolerance Setting [RTK-X].
5. On the Tolerance 2 dialog box (refer to Figure
55), set the parameters and click OK.
The recommended setting for a short
baseline is:
Position (H): 3cm
Position (V): 6cm
When setting the above parameters,
keep the selection StarFire Dual on
the Solution drop-down list box.
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- SF-2040 Rev.C (178 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)