Figure 12: battery chamber release button – NavCom LAND-PAK Rev.F User Manual
Page 50
LAND-PAK™ User Guide – Rev. F
3-48
Follow these steps to install the battery packs:
1. Open the battery pack chamber (located on the
left-hand side of the SF-3040 as you hold the
receiver with the front facing toward you) by
pressing downward on the black button.
2. Align the battery pack with the chamber.
3. Holding the locking clip to the side, insert a
battery pack into each chamber, metal-contact
end first.
4. Push the locking clips back into place.
Figure 12: Battery Chamber Release Button
5. Repeat steps 2 through 4 with the second battery
pack.
Charge the battery packs only with the
supplied battery chargers (PN 98-
214401); otherwise, damage to the
battery packs could occur.
Remove the battery packs from the
SF-3040 GNSS receivers if they will
not be used for more than one week.
Batteries are not charged in the unit. If
external power is applied, the SF-3040
battery LEDs indicate the status of the
batteries, not the status of the external
power source.
Release
Button
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- SF-2040 Rev.C (178 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)