Figure 67: set frequency – NavCom LAND-PAK Rev.F User Manual
Page 115
LAND-PAK™ User Guide – Rev. F
A-116
b. Press the up or down arrow soft key to
change the value of the digit, if needed.
c. Repeat steps a and b, above, for each
configurable digit.
When the cursor is at the last configurable
digit, the Set option appears in the bottom
right of the LCD display (see Figure 67).
Figure 67: Set Frequency
d. Change the value of the last configurable digit,
if needed.
e. Press the Set soft key to set the frequency
changes. Or, press the Cancel soft key to
cancel the changes.
If the frequency is set within the
acceptable range, a confirmation message
is displayed temporarily. Then the main
menu returns.
If the frequency is set outside the
acceptable range, an error message is
displayed temporarily. Then the main
menu returns. No change is made to the
center frequency. Repeat the RF
frequency configuration procedure to
change the frequency.
If the frequency changes are canceled, the
display returns to the main menu.
4. Continue to the next section, to configure the RF
power output.
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- SF-2040 Rev.C (178 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)