Directed Electronics VIPER 3203 - Manual (Page 28)

25 © 2009 Directed Electronics. All rights reserved.
Valet Mode
Valet mode can be entered and exited by performing the remote valet
command or manually using the vehicle key and the control button.
When entered, the alarm functions are defeated while the conve-
nience features still operate normally.
Arm and disarm commands lock and unlock the doors. The Responder
LE emits the arm in valet and disarm in valet output as described for
arm and disarm in the Basic Commands section.
Use the following steps to manually enter and exit valet mode:
Turn 1. the ignition switch on and then off
Immediately 2. press and release the control button once
The control center LED turns on when entering and off when exit- 3.
ing.
Power Save
To reduce power consumption the control center LED modifies its out-
put if the vehicle is parked for an extended period. If armed, the
flashing is reduced after 24 hours. When valet mode is on the control
center LED will turn off after1 hour and will reset each time the ignition
is turned off.
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system will
resume the state it was in at the time of disconnection, when power
is reconnected.
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the arm status.