Trigger zone fault report, Alarm report – Directed Electronics VIPER 3203 User Manual

Page 25

Trigger Zone Fault Report

When armed by remote command the system runs a status check
of the alarm trigger zones. Faulty zones (usually caused by dome
light delay or open trunk) are bypassed and reported via the control
center LED and remote, while all other trigger zones remain active
and are monitored to protect the vehicle. Should a faulty zone self
correct (dome light turns off) it becomes active and is then monitored
normally.
The siren chirps once again a few seconds following the arming
chirps as an audible alert, the control center LED ﬂashes in groups to
indicate the zone number.

Alarm Report

If the alarm was triggered while armed, it will be reported when the
alarm is disarmed via the remote control, siren chirps, parking light
and control center LED ﬂashes. The siren chirps 4 times (or 5 times if
NPC On*), the parking lights ﬂash 3 times, and the control center LED
ﬂashes in groups to indicate the last two zones that were triggered
(see Table of Zones). The report output will repeat for each disarm
operation until the ignition is turned on.

* See

Nuisance Prevention (NPC)

for more details.