Directed Electronics VIPER 3203 - Manual (Page 19)

16 © 2009 Directed Electronics. All rights reserved.
Prepare the remote control
Select the desired car 1 (default) or car 2 operation before proceed-
ing.
Press 1. and hold the button of the remote control for 8 seconds
until the transmit LED turns on, and then release it (If programmed
to operate two systems, ignore the Transmit LED flashes at 3 sec-
onds).
Press
2. and hold the button until the transmit LED flashes off
and on three times.
Press
3. and hold the button until the siren emits one long chirp
to confirm Pairing.
Note: 2-way remote controls MUST also emit a sequence of
chimes to confirm pairing is successful. If not heard, make sure
the system is still prepared and repeat step 3 until successful.
Remote Features
Press the button to access the remote operation features, 2 trans-
mit LED flashes and 2 beeps indicate the remote features menu is
accessed. Press the buttons indicated in the tables below to set the
feature option.
Responder LE
The ghost LED’s next to the button indicate the feature settings.
Feature Button
Press LED on LED off LED Flash LED Double
Flash
Keypad Lock Auto Off
Remote Beeps Beeps On Beeps Off Triggers
only
Car 2 Car 2 On Car 2 Off