Full silent arm protection, Sensor warn-away, Full trigger – Directed Electronics VIPER 3203 User Manual
Page 24: Emergency override
21
© 2009 Directed Electronics. All rights reserved.
Full Silent Arm Protection
Sensor Warn-away, Sensor Full Trigger and Point of Entry activations
will only send messages to the Responder LE remote control, with park-
ing light flash and siren outputs defeated.
Sensor Warn-away
When the system sensors detect a Warn-away trigger the siren chirps
and parking lights flash for 3 seconds. No messages are sent to the
Responder LE remote control for Warn-away triggers.
Full Trigger
An alarm Full Trigger will sound the siren and flash the parking lights
for 30 seconds while sending a Full Trigger message to the remote
control. The ghost LED’s flash and siren tones play for 30 seconds
followed by an alert that consists of 1 long beep per minute for 10
minutes.
To stop the output and alert, press a command button to perform a
command, or Press the
button.
Emergency Override
The following procedure disarms the system when a programmed re-
mote is not available. Number of presses__________
Turn
1.
the ignition On.
Press
2.
the control button on the Control Center the correct
number of times (the default is 1 press).
After a few seconds the siren output ceases and the system
3.
is disarmed.
Note
As a precaution, if programmed for Passive Arming or Auto
re-arming the system should be placed into Valet Mode until
a remote is available .