Directed Electronics VIPER 3203 - Manual (Page 14)

11 © 2009 Directed Electronics. All rights reserved.
Advanced Commands: (Level 2)
Press and release the button 2 times. The and aux LED’s illumi-
nate indicating Level 2
Note: The transmit LED on the 1-way remote will flash in groups of 2
to indicate level 2.
Sensor Bypass
Press and release
Performing the sensor bypass command will incrementally bypass sen-
sor operations and be confirmed as follows:
Warn-away Bypass: s The parking lights flash 2 times. The arm
LED, 1 beep and 1 fault tone play to confirm. Sensors will be
activated for full trigger levels of impact only.
Warn-away & Full Trigger Bypass:
s The parking lights flash 3
times. The arm LED, 1 beep and 2 fault tones play to confirm.
Sensors will not be activated for any level of impact.
Sensor Bypass Off:
s The parking lights flash 1 time. The arm LED
and 1 beep play to confirm. Sensors are fully operational.
Note Sensor bypass can only be performed when the system
is armed. The
LED and a long fault tone plays as an
alert when performing sensor bypass when the system is
disarmed. Perform arm command any time to turn sensor
bypass off.
Remote Valet
Press and release
Enters (or if on, exits) valet mode. The control center LED turns on and