Montigo PVHIN58-300 - Manual (Page 9)

PVHIN58-300 with TMHIN58-40
Page 9
XG0521 - 111214
Step 8. Attach the power cable from the power vent to the control cable.
Step 9. Push all excess cable back into the component cover. Screw electri-
cal plate back on the power vent.
Figure 12. Section 3
Figure 13. Section 3
1” Clearance
Wire
Conduit and Wiring Clearances
Connect the power vent harness as outlined� Connect
the wiring to the fireplace as outlined in the schematic
showin in Figure 14 Section 3� Ensure that the proper
clearances are maintained for the wiring and conduit.
When installing the wiring, it must never run above the
vent pipe and it must be at lest 1" clear of all venting and
other hot surfaces�
Figure 14. Section 3
Installation