Montigo PVHIN58-300 - Manual (Page 14)

PVHIN58-300 with TMHIN58-40
Page 14
XG0521 - 111214
Step 4. Vanity ring install.
There is an optional vanity ring to cover the unfinished edges of rock facing
on the exterior wall around the termination. First, remove the door.
Step 5. To install, place vanity ring around door until vanity ring is flush with
surface of door.
Step 6. Clamp ring in place and drill out holes around the perimeter
of door.
Figure 6 Section 5.
Step 7. Secure vanity ring with stainless steel screws or rivets. Apply
silicone over top of screws or rivets to prevent leaks.
Figure 7 Section 5.
Figure 8 Section 5.
Figure 9 Section 5.
Step 8. Reinstall the door.
Installation