Montigo LDVPV47 - Manual (Page 5)

Page 5
LDVPV47 Linear Power Vent System
XG0750 -112911
Installation
Section:
Installation of Pipe Diluter
The Installation of the LDV Air Circulator Pipe Reducer on your fireplace:
Model No's. that use 4" /7" Vent
1. Install the Pipe Diluter as shown below.
Figure 2a. Installation of 4" / 7" Flue Reducer.
Existing 4" Flue Adapter
Top of Fireplace
Fllue Diluter Collar
Slide Reducer
over 4" Flue
Adapter
Venting Installation
The Internal Power Vent must be installed with a gas fireplace equipped
with an electronic ignition system. When installing the venting, the
installation must adhere to the Venting Installation Section in the
fireplace's Installation Operation and Maintenance Instructions, as well
as the following guidelines:
„ Ensure that the planned termination location is acceptable as
shown in Appendix A.
„ Minimum of 2 feet of straight pipe before the power vent.
Installation of Pipe Reducer & Diluter
The Installation of the LDV Air Circulator Pipe Reducer on your fireplace:
Model No's. that use 5" /8" Vent
1. Install the Pipe Reducer & Diluter as shown below.
Figure 2b. Installation of 5"/8" Flue Reducer.
Existing 4" Flue Adapter
Top of Fireplace
Flue Reducer / Diluter
Slide Reducer/
Diluter over 4"
Flue Adapter
8" to 7" Reducer
See page 11 for detailed part numbers.
See page 11 for detailed part numbers.
Ensure perforated air holes in the new pipe adapter / diluter are not covered
when installing the new pipe connection.
CAUTION