Montigo RX100 - Manual (Page 5)

Installation
Page 5 XT0012 - 092214
D. Battery Holder Installation:
1. Secure the battery holder to the fireplace floor using the supplied
velcro strips. See Figure 15.
Note: The velcro strips act as an electrical isolation, do not attach
the battery holder to any metal part without using the velcro strips, or
the control module will be damaged.
2. Connect the red and black wires from the battery holder to the
red and black wires from the valve harness. See Figure 16.
Figure 15 Battery holder
Figure 16 Battery holder wires
E. Stepper Motor and ON/OFF Switch:
1. Connect the Manual ON/OFF switch to X4 of the control
module.
2. Connect the stepper motor harness to X6
Figure 17 X4 > X6 plugs on control module
X4 and X6 Control Module