Montigo 34FID - Linear - Manual (Page 16)

Page 16
XG0514-150204
I-Series Indoor Gas Fireplace
Installation
Figure 16 Sec.4
Figure 17 Sec.4
Figure 18 Sec.4
3). Using a T20 Torx screw driver, remove the 2 screws that attach
the stepper motor to the valve.
4). Remove the screws, stepper motor and rubber diaphragm.
5). Remove the top 2 screws that hold the control mounting
bracket in place.
Figure 19 Sec.4
Figure 20 Sec.4
Converting the gas regulator on the valve
1). On the right side (control side) of the unit, remove 2 screws
that enable the valve to swing away from the unit.
2). Swing the valve away from the unit in order to get access to
the front of the valve and regulator. Be careful not to damage gas
lines or wires.