Montigo RP620 - Manual (Page 42)

RP620 Power Vent Indoor Gas Fireplace
Page 42
XG0777 - 122014.1
Maintenance
Replacing Light Bulbs
The RP620* light bulbs can be replaced in a few simple steps. Begin
by disconnecting the power to the fireplace. Follow the directions for
removing the screen and outer glass on page 30. Once the screen
and outer glass have been successfully removed, proceed with
figures 28 - 28b.
Note: Always wear gloves when handling the fireplace light bulbs
or glass panels.
Figure 35.
Figure 35a.
Figure 35b.
Step 1: Remove remove any decorative media and up-lighting
glass from the light kit tray.
Step 2: To remove a light bulb, pull the light bulb away from the
light bulb connector and lift the light bulb up and out.
Step 3: Rotate the newly replaced light bulb in a full circle.
Step 4: Replace up-lighting glass in the burner tray.