DirecTV DW65X91 - Manual (Page 53)

53
ADJUSTING TV CONTROLS
Color Temp
Color Temperature displays a list that lets you set one of three automatic color
adjustments: Cool for a more blue palette of picture colors, Medium for neutral picture
colors, and Warm for a more red palette of picture colors.
Convergence
The projection TV uses three separate TV tubes: a red one, a green one, and a blue one.
The red, green, and blue images are projected onto the screen where they converge to
form a full color picture. You can see a clear picture only when they converge correctly.
Convergence may drift over time or if you move the TV. If you can see clear images on the
screen, skip this procedure. This adjustment should be made after the TV has been on for
at least 30 minutes.
To check and adjust the color convergence:
1. Press MENU.
2. Select Picture Quality, and then select Convergence.
3. Press x or • to display the center convergence menu.
If you see separate colored lines, you have to adjust the convergence.
PUSH 0 KEY
PUSH ENTER
TO SE L ECT COL OR
TO SE L ECT POS ON I I T
RED BL UE
PUSH ENTER
TO SE L ECT COL OR
RED BL UE
TO SELECT POS I T I ON
PUSH 0 KEY
(Correct convergence) (Adjustments are needed)
4. Press OK (ENTER) to select RED or BLUE.
5. Press y (up), z (down), x (left), • (right) to converge the red or blue line into the
green line. When color convergence is correctly adjusted, you will see two single
white lines.
6. Press “0” to display the circumference convergence menu.
7. Press the corresponding Number button (1-9) to select the place you want to adjust.
PUSH 1–9
1 2 3
4 6
7 8 9
PUSH 0 KEY
PUSH ENTER
TO SE L ECT COL OR
RED BL UE
TO SELECT POS I T I ON
8. Press OK (ENTER) to highlight RED or BLUE.
9. Press y z x • to converge the red or blue line into the green line.
Repeat steps 8 and 9 until you see two single white lines.
10. Press 1-9 to select any other place you want to adjust, then repeat steps 7 through 9.
11. Press EXIT to close the convergence menu.