DirecTV DW65X91 - Manual (Page 18)

18
SETUP AND CONNECTIONS
other than Dolby Digital AC-3 or PCM receiver or decoder could create a high noise level, causing
damage to headphones or speakers.
Connecting two VCRs
This connection allows you to record (dub/edit) from one VCR to another VCR while
watching a video program. You will also be able to record from one TV channel while
watching another channel.
ANTENNA-IN
A B
SATELLITE-IN
ACCESS CARD
PHONE
JACK
TOP OF CARD
FACE DOWN
OUT IN IN
HD 1 HD 2
IN
CHANNEL IN
ON OFF
OUT
R L VAR
AUDIO
VIDEO
L/
MONO
AUDIO CENTER
L
R
P B
P R
Y
L/
MONO
AUDIO AUDIO AUDIO
S-VIDEO
VIDEO
R
VIDEO-1 VIDEO-2
COLOR
STREAM
R
L
R
P B
P R
Y
AUDIO
COLOR
STREAM
ANT( 75 )
ANT-1 OUT ANT- 2
VIDEO AUDIO
CH 3
L R
CH 4
IN
OUT
VIDEO AUDIO
CH 3
L R
CH 4
IN from ANT OUT to TV
IN
OUT
DIGITAL
OPTICAL
AUDIO-OUT
Connecting a stereo amplifier
This connection allows you to use an audio amplifier to adjust the audio level. This also
allows you to use external speakers.
To control the audio, turn on the TV and the stereo amplifier, then turn off the built-in
speakers. (See “AUDIO CONTROLS” on pages 54-55.)
LINE IN
L R
OUT IN IN
HD 1 HD 2
IN
CHANNEL IN
ON OFF
OUT
R L
VAR
AUDIO
VIDEO
L/
MONO
AUDIO CENTER
L
R
P B
P R
Y
L/
MONO
AUDIO AUDIO AUDIO
S-VIDEO
VIDEO
R
VIDEO-1 VIDEO-2 COLOR
STREAM
R
L
R
P B
P R
Y
AUDIO
COLOR
STREAM
ANT( 75 )
ANT-1 OUT ANT- 2
Caution:
Do not connect one VCR to the
output and input jacks on the TV at
the same time. If you are using a S-
VHS VCR, use the S-video
connections and remove the video
cable. Do not connect the video
cable and the S-video cable to
VIDEO 1 simultaneouly.
The unauthorized recording of
television programs, video tapes and
other materials may infringe upon
the provision of copyright laws.
Note:
To dub or edit, the VCR 2 must
select Line IN, and the TV must
select V-1.
From Antenna
VCR 1
TV
VCR 2
Amplifier
TV