High frequency, Owner recognition, Rapid resume logic – Directed Audio 2 Way Security and Conveniece System VSS-204TW User Manual

Page 22: Power saver mode

High frequency

Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less

interference and a more stable signal. Enjoy a phenomenal increase in range – even in areas with

high radio interference.

Owner recognition

Using a hand-held programming tool, your dealer can program many of the system settings. The

programmer makes it possible to program different settings for each transmitter that is used with

the system. Then, whenever a specific transmitter is used, the system will recall the settings

assigned to that transmitter. Owner Recognition lets up to four users of the system have different

settings that meet their specific needs. It is almost like having four separate alarms in your vehicle,

one for each user.

NOTE: Owner Recognition cannot be programmed

without a programming tool and the necessary software.

Check with your dealer for more information.

Rapid resume logic

This system will store its current state to non-volatile memory. If power is lost and then

reconnected, the system will recall the stored state from memory. This means if the unit is in Valet

Mode and the battery is disconnected for any reason, such as servicing the car, when the battery

is reconnected the unit will still be in Valet Mode. This applies to all states of the system including

arm, disarm, VRS

, and Valet Mode.

Power saver mode

Your system will automatically enter Power Saver Mode while armed or in Valet

Mode, after a

period of time in which no operation has been performed. This lowers the current draw to the

vehicle’s battery. Power Saver Mode takes over under the following conditions:

Power Saver when the system is armed: After the system has been armed for 24 hours, the

in-vehicle LED will flash at half its normal rate, decreasing the system's current draw.

Power Saver in Valet

Mode: When the system enters Valet

Mode the in-vehicle LED

illuminates steadily. If the vehicle is not used (ignition is not turned on) for a period of one

hour while the system is in Valet

Mode, the LED will shut off. If the system remains in Valet

Mode, the LED will come back on the next time the ignition is turned on and then back off.