Grouped multi-level arming, Disarming – Directed Audio 2 Way Security and Conveniece System VSS-204TW User Manual

Page 12

bypassed.

Press

a third time within five seconds: The parking lights flash three times. Zone 4 is now

bypassed.

Press

a fourth time within five seconds: The parking lights flash four times. Zone 7 is now

bypassed.

Press

a fifth time within five seconds: The parking lights flash five times. Zones 2 and 4

are now bypassed.

Press

a sixth time within five seconds: The parking lights flash six times. Zones 2 and 7 are

now bypassed.

Press

seven times within five seconds: The parking lights flash seven times. Zones 4 and 7

are now bypassed.

Press

eight times within five seconds: The parking lights flash eight times. All zones

except zone 5 are now bypassed.

NOTE: Multi-Level Security Arming only applies to a

single arming cycle. Once the system is disarmed and

then re-armed, all the zones will be active again.

After each press of the

to reach the next level of security, the remote will emit normal

arm notification (1 beep and 5 flashes of the

icon). For easiest operation in reaching each

level of security, press

immediately after each notification.

ROUPED

ULTI

-L

EVEL

RMING

After arming, immediately press the

button once. The parking lights will flash 3 times and all

the sensors warn-away zones will be bypassed.

After arming, immediately press the

button twice. The parking lights will flash 4 times and all

the sensors warn-away and full alarm zones will be bypassed. All remaining zones are still active.

ISARMING

To disarm the system, press

. You will hear two chirps, and the parking lights will flash twice. If

the power locks are connected to the system, the doors will unlock. If the siren chirps either four

or five times when disarming, refer to the Diagnostics section of this guide. This is called Tamper

Alert.

The remote will indicate disarm notification with 2 beeps and 5 flashes of the icon. If disarming

after the system has been triggered, the remote control will send a diagnostic notification as a

reminder. These diagnostic notifications are:

1. If a sensor triggered the system, the remote will emit 4 quick beeps and the LCD screen will

indicate which sensor (5- flashes) tripped the alarm.