beautypg.com

Diagnostics, Arming diagnostics, Disarming diagnostics – Directed Audio 2 Way Security and Conveniece System VSS-204TW User Manual

Page 20: System status chirps, Rming diagnostics, Isarming diagnostics, Ystem status chirps

background image

Diagnostics

The microprocessor at the heart of your security system is constantly monitoring all of the

switches and sensors that are connected to it. It detects any faulty switches and sensors and

prevents them from disabling the entire system. The microprocessor will also record and report

any triggers that occurred during your absence. Refer to the System Status Chirps and Table of

Zones charts for diagnostic information.

A

RMING DIAGNOSTICS

If the system is armed while an input is active (door open, sensor triggering, etc.) the unit will

chirp once when arming and then one more time a few seconds later. This is called Bypass

Notification.

NOTE: Bypass N

OTIFICATION

will not occur when using

Silent Mode™ or if chirps have been programmed OFF.

The security system will ignore the input that was active when the system was armed, until the

input goes away. Three seconds later the system will monitor that input normally. For example, if

your vehicle has interior light exit delay, and you arm the system before the interior light goes

out, you may hear Bypass Notification chirps. Once the light shuts off, however, the doors are

monitored normally.

D

ISARMING DIAGNOSTICS

Extra disarm chirps are the Tamper Alert. If four chirps are heard when disarming, the system was

triggered in your absence. If five chirps are heard, a zone was triggered so many times that

Nuisance Prevention

®

Circuitry has bypassed that zone. The in-vehicle status LED will indicate

which zone was involved. (See Table of Zones section of this guide.) The system will retain this

information in its memory, and continue to chirp four or five times each time it is disarmed, until

the next time the ignition key is turned on.

S

YSTEM STATUS CHIRPS

The siren will chirp when arming/disarming the system. The pattern of chirps will audibly report

the system’s status as described below.

Action

Number of Chirps

Description

Arm 1

System

armed

Arm

1 + 3 sec delay + 1

System armed with Bypass Notification

Disarm 2

System

disarmed

Disarm

4

System disarmed with Tamper Alert

Disarm

5

System disarmed NPC

®

active

17

© 2006 Astroflex Electronics - All rights reserved