To exit programming mode, Using your system, Active arming – Directed Audio 2 Way Security and Conveniece System VSS-204TW User Manual

Page 10

AGE NOTIFICATION

The remote control can be programmed to notify the user of a page (audibly beeping if the

vehicle’s status changes, e.g. door unlocked, engine started, vehicle violation, etc.). On the LCD

remote press

to select page On/Off. One beep is page On, Two beeps is page Off. When

programmed off the remote will not give any notification that a page was received from the

vehicle.

Page notification

Programming response

1 beep, page notification ON

OFF

2 beeps, page notification is OFF

NOTE: If programmed Off, no alarms will

be notified to the remote. Command information

(armed/disarmed) will be notified to the remote.

O EXIT PROGRAMMING MODE

The LCD remote control will exit programming mode after 5- seconds of inactivity and will emit 1

long beep.

Using your system

The buttons described in this manual correspond to the standard configuration. Remember, this is

not the only way your transmitter may be set up. It can be custom configured to meet your

needs. See your installer for additional details.

CTIVE ARMING

You can arm the system by pressing

of your remote for one second. When the system arms,

from the vehicle you will hear a short siren sound, or chirp, and see the parking lights flash once.

If the power door locks are controlled by the system, the doors will also lock.

While the system is armed, the in-vehicle’s status LED will flash approximately once per second,

indicating that the system is actively protecting your vehicle. If you hear a second chirp after

arming and note that the in-vehicle’s status LED is flashing in groups, see the Diagnostics Section

of this guide. This extra chirp is called Bypass Notification.

The LCD remote responds to active arming with one beep and the icon will flash 5-times to
indicate successful arming of the system.

If the LCD remote beeps twice after arming, the system has detected an active sensor that should

be checked. For example, a door open icon will be displayed flashing 5-times on the LCD screen.