Measurement Computing DaqTemp - Manual (Page 34)

5-4 CE-Compliance 08-27-02 DaqTemp Series User’s Manual
Install the DaqTemp PCI Board with its CE ORB
If you are installing the DaqTemp Series Board for the first time, refer to chapter 2 of this manual,
How to Install DaqTemp.
1. If you have not already done so, turn off power to, and UNPLUG the host PC and externally
connected equipment. Then remove the PC’s cover. Refer to your PC Owner’s Manual as needed.
2. Install the DaqTemp Series PCI Board [with CE ORB] as follows (see following figure).
(a) Align the groove in the edge connector with the ridge on the PCI slot.
(b) Push the DaqTemp PCI Board firmly into the PCI slot.
(c) Replace the rear panel adapter screw.
3. Replace the PC’s cover.
Installing a DaqTemp PCI Board