Measurement Computing DaqTemp - Manual (Page 26)

2-6 How to Install DaqTemp 10-14-02 DaqTemp User’s Manual
Step 5
– Connect the DaqTemp Module to its PCI Board
Connecting the DaqTemp Module to the PCI Board
CAUTION CAUTION CAUTION CAUTION
Turn off power to and unplug the host PC prior to connecting the DaqTemp to
the computer. Failure to do so could possible result in equipment damage.
Prior to mating the CA-195 cable’s P4 connectors to the PCI board and the
DaqTemp, be sure to align the P4 orientation indicators (
▲ ▲ ▲ ▲) of the connectors
that are being mated.
Connect the DaqTemp module to its PC-based PCI board as follows.
1. Turn off and unplug the PC.
2. Ensure that the P4 connector alignment indicators (
▲ ▲ ▲ ▲) on cable CA-195 and the DaqTemp module are
in alignment, and make the connection of cable to DaqTemp module.
3. Align the cable’s remaining P4 connector with the PCI board’s P4 connector, then make the
connection.
At this point you can connect the signal lines to the DaqTemp module’s terminal blocks.
Refer to chapter 3 for details.