Measurement Computing USB-2416 - Manual (Page 39)

USB-2416 User's Guide Specifications
39
Power
The USB-2416 product includes an AC power adapter (MCC part number PS-5V2AEPS).
Table 26. Power specifications
Parameter Conditions Specification
Supply current (Note 8) Quiescent current 330 mA
External power input (Note 9) +5 V, ±5%
External power supply MCC p/n PS-5V2AEPS (included) +5 VDC, 10 W, 5%
regulation
Voltage supervisor limits 4.5 V > V ext or V ext > 5.5 V PWR LED = Off; (power
fault)
4.5 V < V ext < 5.5 V PWR LED = On
+5V user output voltage range Available at terminal block pin 35 4.9 V minimum to 5.1 V
maximum
User +5V user output current Available at terminal block pin 35 10 mA maximum
Isolation Measurement system to PC 500 VDC minimum
Table 27. AC power requirements
Parameter Conditions Specification
Output voltage +5 V, ±5%
Output wattage 10 watts
Power jack configuration Two conductor
Power jack barrel diameter 6.3mm
Power jack pin diameter 2.0mm
Power jack polarity Center positive
Note 8: This is the total quiescent current requirement for the USB-2416 which includes up to 10 mA for the status
LED. This does not include any potential loading of the digital I/O bits or the +5V user terminal.
Note 9: This specification applies to the actual voltage level at the input to the external power connector of the
USB-2416.
USB specifications
Table 28. USB specifications
USB device type USB 2.0 (full-speed)
Device compatibility USB 1.1, USB 2.0
USB cable type A-B cable, UL type AWM 2527 or equivalent. (minimum 24 AWG VBUS/GND,
minimum 28 AWG D+/D–)
USB cable length 5 meters maximum
Environmental
The environmental specifications listed in Table 29 apply only to the USB-2416 and not to the AC power
adapter.
Table 29. Environmental specifications
Operating temperature range 0 to 50° C maximum
Storage temperature range -40 to 85 ° C maximum
Humidity 0 to 90% non-condensing maximum