beautypg.com

Counter, Memory, Microcontroller – Measurement Computing USB-2416 User Manual

Page 38

background image

USB-2416 User's Guide

Specifications

38

Note 5: The external pull-up is connected to the digital output bit through an external pull-up resistor. Adding an external pull-

up resistor connects it in pa

rallel with the internal 47k Ω pull-up resistor of that particular digital input/output bit.

Careful consideration should be made when considering the external pull-up resistor value and the resultant pull-up
voltage produced at the load.

Note 6: Does not include the additional leakage current contribution that may occur when using an external pull-up resistor.

Counter

Table 23. CTR specifications

Parameter

Conditions

Specification

Pin name

CTR0, CTR1

Number of channels

2 channels

Resolution

32-bits

Counter type

Event counter

Input type

Schmitt trigger, rising edge triggered

Input source

CTR0 (pin 43)
CTR1 (pin 45)

Counter read/writes rates
(software paced)

Counter read

System dependent, 500 reads per second.

Counter write

System dependent, 500 reads per second.

Input characteristics

Each CTRx input pin

562 K

Ω pull-up resistor to +5V, 10 kΩ series

resistor

Input voltage range

±15 V maximum

Maximum input voltage range

CTR0,CTR1 relative to GND and
DGND (pins
18,36,39,42,44,46,66,81,84,93,94)

±20 V maximum (power on/off)

Input high voltage

1.3 V minimum, 2.2 V maximum

Input low voltage

1.5 V maximum, 0.6 V minimum

Schmitt trigger hysteresis

0.4 V minimum, 1.2 V maximum

Input bandwidth (-3 db)

1 MHz

Input capacitance

25 pf

Input leakage current

±120 nA

Input frequency

1 MHz maximum

High pulse width

500 ns, minimum

Low pulse width

500 ns, minimum

Note 7:

The DGND and GND pins (pins 18,36,39,42,44,46,66,81,84,93,94) are common and are isolated from
earth ground.

Memory

Table 24. Memory specifications

EEPROM

4096 bytes isolated micro reserved for sensor configuration
256 bytes USB micro for external application use

Microcontroller

Table 25. Microcontroller specifications

Type

One high-performance 8-bit RISC microcontroller with USB interface (non-isolated)
One high-performance 16-bit RISC microcontroller for measurements (isolated)