Measurement Computing USB-2020 - Manual (Page 7)

Chapter 2
Installing the USB-2020
What comes with your USB-2020 shipment?
Hardware
 USB-2020
 USB cable (2-meter length)
 External power supply and cord: 9 VDC, 3 A power adapter. MCC part number CB-PWR-9
 Four nylon standoffs
Software
MCC DAQ Software CD
Documentation
MCC DAQ Quick Start Guide
The Quick Start Guide booklet provides an overview of the MCC DAQ software you received with the device,
and includes information about installing the software. Please read this booklet completely before installing any
software or hardware.
Optional components
 Cables
o
Standard BNC cable
o
C40FF-x
o
C40-37F-x
 Screw termination boards
o
CIO-MINI40
o
CIO-MINI37
o
SCB-37
Unpacking
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the USB-2020 from its packaging, ground yourself using a wrist strap or by simply
touching the computer chassis or other grounded object to eliminate any stored static charge.
If your USB-2020 arrives already damaged, notify Measurement Computing Corporation immediately by
phone, fax, or email.

Knowledgebase: kb.mccdaq.com
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support
 Fax: 508-946-9500 to the attention of Tech Support
 Email: [email protected]
For international customers, contact your local distributor. Refer to the International Distributors section on our
website at www.mccdaq.com/International .
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the MCC DAQ CD. This booklet is
available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf .
7