Measurement Computing CIO-PDISO16 - Manual (Page 9)

CIO-PDISO16 User's Guide Installing the CIO-PDISO16
8
Unpacking the board
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the CIO-PDISO16 from its packaging, ground yourself using a wrist strap or by
simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If any components are missing or damaged, notify Measurement Computing Corporation immediately by
phone, fax, or e-mail:
 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.
 Fax: 508-946-9500 to the attention of Tech Support
 Email:
[email protected]
Installing the software
Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data
Acquisition Software CD. This booklet is available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-
Quick-Start.pdf .
Configuring the CIO-PDISO16
The CIO-PDISO16 has one base address switch, two sets of input filter switches, and one wait state jumper
which you must set before installing the board in your computer. The InstaCal calibration and test program
included with the CIO-PDISO16 will show you how to set the switches. Run InstaCal before you open your
computer and install the board. The CIO-PDISO16 is shipped with the factory-default settings listed below.
Factory-configured default settings
Switch/jumper Default setting
Base address switch 300h (768 decimal)
Input filter select switches On position
Wait state jumper OFF position
Base Address
switch
Input Filter Select
switch (up=ON)
Wait State jumper
Input Filter Select
switch (up=ON)
Figure 1. Switch and jumper locations