Measurement Computing CB-NAP-7000D - Manual (Page 31)

NAP7000D User Manual (Version 1.0) ---- 31
2.10 Setting CB-7042, CB-7043 and
CB-7067
Step1: Check a ConvN(here N means 0 to 31) to start the setting CB-7000 module
configuration. In this example, the Conv9 is checked.
Step 2: Select the desired module type as Fig 2-10 shown(method 1 or method 2).
In this case, please select 7042, 7043 or 7067. In this examples, the 7042 is selected.
Step 3: After selecting 7042, a window titled setting Configuration for 7042 will
pop up as Fig 2-24 shown.
Fig 2-24 The setting Configuration for 7042 window.
This window given some information about the CB-7042 module. Because CB-7042
is just a digital output module. The portion of Digital input is gray that means the user
can not set in this portion. And the portion of Digital Output show that there are 13
digital output channel. As the CB-7021, the user can decide the output value with 3
ways. Those are Output Assigned Value, Output ReadBack Value and Output via