Setting the cb-7017, cb-7018 – Measurement Computing CB-NAP-7000D User Manual

Page 22

NAP7000D User Manual (Version 1.0) ---- 22

2.7 Setting the CB-7017, CB-7018

Step1:

Check a ConvN(here N means 0 to 31) to start the setting CB-7000 module

configuration. In this example, the Conv8 is checked.

Step 2:

Select the desired module type as Fig 2-10 shown(method 1 or method 2).

In this case, please select 7017 or 7018. In this examples, the 7017 is selected.

Step 3:

After selecting 7017, a window titled 7017/7018 Channel selection will

pop up as Fig 2-14 shown. The user can check the desired input channel to received

analog input data. Or just push Select All button to select all eight channels. After

check the desire channels then push OK button to complete the channel selection. Or

pushing Cancel button to cancel the channel selection.

Fig 2-14 The 7017/7018 Channel Selection window.