MEGA Corp. MTT-OPS-1 - Manual (Page 7)

MTT-OPS-1
13 Nov 2013
SECTION 1
Definitions and Abbreviations
1-4
ROTATING SHAFT (8)
This safety label is located on the pump.
Do not place your hand or tools within pump bell
while pump is rotating and/or pressure held
within the motor supply hose. Refer to the
Operator and Maintenance Manual for the
procedures to operate and maintain the pump.
Failure to follow proper procedures could result in
serious injury.
HIGH PRESSURE SPRAY HEADS (9)
This safety label is located on the spray bar.
Do not operate spray heads until all personnel are
a safe distance away from the vehicle.
HIGH PRESSURE WATER CANNON (10)
This safety label is located on top of the cab control
box.
Do not operate the water cannon until all
personnel are a safe distance away from the
vehicle.
HIGH PRESSURE MOTOR (11)
This safety label is located on the hydraulic motor.
Hydraulic motor and supply lines contain oil
under high pressure. Improper removal and
repair procedures could cause severe injury. To
remove or repair, instructions in the Maintenance
Manual must be followed.