MEGA Corp. MTT-OPS-1 - Manual (Page 30)

MTT-OPS-1
13 Nov 2013
SECTION 4
Normal Operations
4-3
Once operations are complete:
5. PUMP Switch – OFF
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
6. Cab Control SYSTEM/POWER Switch – OFF
WATER CANNON
1. Cab Control SYSTEM/POWER Switch – ON
2. PUMP Switch – ON
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
3. Water Cannon – Pointed in a safe direction.
4. MONITOR/BFV Switch – ON
5. Water Cannon Joystick – As Required.
6. MONITOR/BFV Switch – OFF
Once operations are complete:
7. Water Cannon Nozzle - STOW
Manual and remote adjustable nozzles must be
stowed pointing vertically to reduce wear on
water cannon joints. Leaving the nozzle in any
other position will cause increased wear on water
cannon joints and result in premature joint
failure.
8. PUMP Switch – OFF
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
9. Cab Control SYSTEM/POWER Switch – OFF
FIRE SUPPRESSION SYSTEM
1. Cab Control SYSTEM/POWER Switch – ON
2. PUMP Switch – ON
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
3. Water Cannon – Pointed in a safe direction.
4. FOAM Switch – ON
5. MONITOR/BFV Switch – ON
6. Water Cannon Joystick – As Required.
Once operations are complete:
7. FOAM Switch – OFF
8. Water Cannon – Flow water through the monitor
nozzle with the FOAM switch off to flush foam
from the nozzle.
9. MONITOR/BFV Switch – OFF
10. Water Cannon Nozzle – STOW
Manual and remote adjustable nozzles must be
stowed pointing vertically to reduce wear on
water cannon joints. Leaving the nozzle in any
other position will cause increased wear on water
cannon joints and result in premature joint
failure.