Denon AVR-3802 - Manual (Page 45)

45
After starting playback
[1] Adjusting the sound quality (TONE)
The tone control function will not work in the direct mode.
1 The tone switches as follows each time the TONE CONTROL
button is pressed.
TONE
CONTROL
(Main unit)
2 With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
SELECT
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
[3] Turning the sound off temporarily (MUTING)
1 Use this to turn off the audio output
temporarily.
Press the MUTING button.
Cancelling MUTING mode.
Press the MUTING button again.
MUTING
B
1
1 2 3
SKIP
SKIP
ENTER
+
-
+
-
TUNER PHONO CD
SHIFT
MUTING
TUNING
1
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –12 dB
in steps of 2 dB.)
[2] Listening over headphones
1 Connect the headphones to the
PHONES jack of the front panel.
1
PHONES
2
OUTPUT
• The output to the speaker and pre-out jacks is turned off
and no sound is produced from the speakers.
Caution: Switching off the power of the unit and the unit will
cancel the settings.
B
2 3 1
(Main unit)
(Remote control unit)
Press the OUTPUT button to play the sound over the
headphones only.
+10 0 TV/
VCR
SURROUND
OUTPUT TEST TONE SPEAKER
5CH / 7CH
STEREO
DOLBY/DTS
SURROUND DSP
SIMU.
2
BASS TREBLE
3 If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
TONE DEFEAT
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.