Denon AVR-3802 - Manual (Page 37)

37
4 Use the D and H cursor buttons to display “RESET SYS” on
the remote control unit, then press the ENTER button.
• “SYS SEL” appears on the remote control unit’s display.
The remote control unit’s display switches as shown
below each time the
D and H cursor buttons are pressed.
q To reset CALL 1 or CALL 2, select “SYS CALL 1” or SYS
CALL 2”, then press the ENTER button.
w To reset system call settings registered at other buttons,
select “SYS MODE”, press the ENTER button, press the
mode button at which the button is registered, then press
the ENTER button again.
BAND MODE
TUNING
TUNING
ENTER
SHIFT
ENTER
SHIFT
6 “CONFIRM” is displayed. To reset the setting, press the
ENTER button while “CONFIRM” is displayed.
• “SYS SEL” appears on the remote control unit’s display.
ENTER
SHIFT
(2) Resetting the preset memory
1 2 3
4 5 6
7 8 9
+10 0 TV/
VCR
OFF
TV CD CDR/MD/ TAPE RECEIVER
VCR DBS/CABLE
SKIP
SKIP
ENTER
MEMORY
VOLUME CHANNEL
+
-
+
-
VDP DVD
POWER
REMOTE CONTROL UNIT
RC-883
ON /
SOURCE
TUNER
VDP
VCR-1 VCR-2 /V.AUX
DVD
TV/DBS
CDR/ TAPE
PHONO CD
SURROUND
INPUT
OUTPUT TEST TONE SPEAKER
6.1 / 7.1 SURROUND
5CH / 7CH
ANALOG EXT.IN MODE
CALL 2 BACKLIGHT CALL 1
STEREO
STEREO DOLBY/DTS
SURROUND DSP SIMU.
DISPLAY
SYSTEM CALL
DIRECT
RETURN SETUP
MENU
SHIFT
SURR. PARA. OSD
A/B
MUTING
BAND MODE
TUNING
TUNING
1
3, 4, 5
2, 3, 4, 6, 7
1
2
3
ON /
SOURCE OFF
ENTER
SHIFT
BAND MODE
TUNING
TUNING
ENTER
SHIFT
Press the power ON/SOURCE button and the OFF button at
the same time.
• “SET UP” appears on the remote control unit’s display.
Press the ENTER button.
Use the D and H cursor buttons to display “RESET” on the
remote control unit, then press the ENTER button.
RESET PRE RESET LRN
RESET ALL RESET SYS
5 Press the D and H cursor buttons to select the system call
setting to be reset.
The remote control unit’s display switches as shown
below each time the
D and H cursor buttons are pressed.
BAND MODE
TUNING
TUNING
SYS MODE SYS CALL 1
SYS CALL 2
ENTER
SHIFT