Denon AVR-3802 - Manual (Page 40)

40
Auto search function
• The set is equipped with a function for searching for the registration
number if you do not know the preset code (a 4-digit number) when
setting the preset memory.
1
2
For TV, DBS or CABLE components, turn on the component’s
power. For CD, MD, TAPE, DVD, VCR and VDP component’s,
turn on the component’s power and load a disc or tape.
Press the power ON/SOURCE button and the OFF button at
the same time.
• “SET UP” appears on the remote control unit’s display.
If you press the power OFF button late at step 6, press the D and
H cursor button once to move to the next code or back to the
previous code one step at a time.
D button: Next code
H button: Previous code
Auto search resumes when you move ahead from the code at
which you stopped.
1 2 3
4 5 6
7 8 9
+10 0 TV/ VCR
OFF
TV CD CDR/MD/ TAPE RECEIVER
VCR DBS/CABLE
SKIP
SKIP
ENTER
MEMORY
VOLUME CHANNEL
+
-
+
-
VDP DVD
POWER
REMOTE CONTROL UNIT
RC-883
ON / SOURCE
TUNER
VDP
VCR-1 VCR-2 /V.AUX
DVD
TV/DBS
CDR/ TAPE
PHONO CD
SURROUND
INPUT
OUTPUT TEST TONE SPEAKER
6.1 / 7.1
SURROUND
5CH / 7CH
ANALOG EXT.IN MODE
CALL 2 BACKLIGHT CALL 1
STEREO
STEREO DOLBY/DTS
SURROUND DSP SIMU.
DISPLAY
SYSTEM CALL
DIRECT
RETURN SETUP
MENU
SHIFT
SURR.
PARA. OSD
A/B
MUTING
BAND MODE
TUNING
TUNING
2
6
4, 5
3, 4, 5, 7
3
4
5
6
7
ON /
SOURCE OFF
ENTER
SHIFT
BAND MODE
TUNING
TUNING
ENTER
SHIFT
BAND MODE
TUNING
TUNING ENTER
SHIFT
OFF
ENTER
SHIFT
Press the ENTER button.
Use the D and H cursor buttons to display “AUTOSEARCH”
on the remote control unit, then press the ENTER button.
Use the D and H cursor buttons to display the mode of the
component to be searched for on the remote control unit’s
display, then press the ENTER button.
• The registration codes are transmitted in order.
When the component operates, press the POWER OFF
button.
• The mode and the registered number appear on the remote
control unit’s display.
The channel switches on the TV, DBS or CABLE device and
playback stops on a CD, MD, tape, DVD, VCR or VDP player.
Press the ENTER button.
• “COMPLETE” is displayed on the remote control unit’s
display and the selected code is preset.