Marantz M-CR610 - Manual (Page 16)

16
Appendix Tips Settings Playback Contents
Front panel Rear panel Index Remote
Connections
Speaker connection
Here we connect the speakers in the room to this unit.
This section explains how to connect them using typical examples.
NOTE
• Disconnect this unit’s power plug from the power outlet before connecting the
speakers. Also, turn off the subwoofer.
• Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and – sides touch each other (vpage 115 “Protection circuit”).
• Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
• Use speakers with an impedance of 6 – 8 Ω/ohms. The protection circuit may be
activated if speakers with an impedance other than specified are used.
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and – (black)
polarities on the speakers being connected to this unit, and be sure to
connect the channels and polarities correctly.
1 Peel off about 10 mm of sheathing from
the tip of the speaker cable, then either
twist the core wire tightly or terminate it.
2 Turn the speaker terminal counterclockwise
to loosen it.
3 Insert the speaker cable’s core wire to the
hilt into the speaker terminal.
4 Turn the speaker terminal clockwise to
tighten it.