Datalogic Scanning DS6400 - Manual (Page 109)

MAINTENANCE
5
5 MAINTENANCE
5.1 CLEANING
Clean the laser beam output window (Figure A, 7) periodically for correct operation of the
scanner.
Dust, dirt, etc. on the window may alter the reading performance.
Repeat the operation frequently in particularly dirty environments.
Use soft material and alcohol to clean the window and avoid any abrasive substances.
WARNING
the scanner is turned off or at
least when the laser beam is not active.
Clean the window of the DS6400 when
5.2 AUTOMATIC SCANNER REPLACEMENT (ASR)
The Datalogic Automatic Scanner Replacement (ASR) procedure allows restoring system
nctioning automatically after one or more scanners are replaced in a Master/Slave
he ASR procedure is principally used for PackTrack™ configurations, since it restores the
he Master must be prepared at the time of installation in order for this procedure to work
orrectly.
1.
p Lon Slave Scanner
Configuration parameter in Genius™ and configure the Lonworks Slave Scanner
. Enable the ASR procedure through the Enable A.S.R. parameter in the Master
3.
tion to the Master EEPROM to force the Slave Operating Mode, Code
eading Symbologies, Reconstruction parameters and store all the Slave PackTrack™
Now the Slave scanners are configured through the Master and the ASR procedure is
fu
Lonworks network.
T
PackTrack™ calibration from the slave scanner to be substituted to the new scanner.
T
c
5.2.1 ASR Network Configuration
On the Master scanner, check the Modify & Backu
Common Parameters (Code and Reconstruction Parameters).
2
configuration.
Send the configura
R
calibration tables.
implemented.
4. Save this configuration to file (.ddc).
93