Kleenmaid FEG900X - Manual (Page 30)

30
GAS SUPPLY:
[
The connection must be executed by an authorised person according to the
relevant standards.
[
This appliance is suitable for use with Natural Gas or LPG-Propane (Check the “gas
type” sticker attached to the appliance).
[
Before connecting the appliance to the gas main, mount the brass conical
adaptor onto the gas inlet pipe, upon which the gasket has been placed (figures
30a-30b). Conical adaptor and gasket are supplied with the appliance (packed
with conversion kit for use with Natural gas or LPG-Propane).
[
For Natural Gas models the gas supply is connected to the pressure regulator which is
supplied with the appliance (fig.30b). Adjust the regulator to obtain a test point pressure
of 1 kPa with the wok burner operating at maximum.
[
For LPG-Propane models the gas supply is connected to the test point adaptor which is
supplied with the appliance (fig.30a) and ensure that the supply pressure is regulated to
2,75 kPa.
[
The connection must be made at the rear of the appliance (left or right); the pipe should
not cross the cooker (fig. 28).
[
The terminal not used must be closed off with the plug and gasket supplied.
[
IMPORTANT: To screw the connecting tube operate with 2 spanners (fig. 29).
Fig. 28
Plug
Fig. 29