Kleenmaid FEG900X - Manual (Page 23)

INSTALLATION
23
CAUTION:
[
In order to avoid a hazard this appliance must be installed according to these
instructions for installation.
[
The appliance should be installed and serviced by a registered technician in
compliance with current local regulations.
[
Incorrect installation, for which the manufacturer accepts no responsibility,
may cause personal injury or damage.
[
Always disconnect the cooker from mains power supply before carrying out
any maintenance operations or repairs.
[
In the room where the cooker is installed, there must be enough air to allow
the gas to burn correctly, according to the current local regulations.
ELECTRICAL REQUIREMENTS
[
The appliance must be connected to the mains checking that the voltage
corresponds to the value given in the rating plate and that the electrical cable
sections can withstand the load specified on the plate.
[
The plug must be connected to an earthed socket in compliance with safety
standards.
[
If the appliance is supplied without plug, fit a standard plug which is suitable for the
power consumed by the appliance.
[
The appliance must be connected directly to the mains placing an omnipolar
switch with minimum opening between the contacts of 3 mm between the
appliance and the mains.
[
The power supply cable must not touch the hot parts and must be positioned so
that it does not exceed 50°C above ambient.
[
Once the appliance has been installed, the switch or socket must always be
accessible.
[
If the power supply cable is damaged it must be substituted by a suitable cable
according to current electrical regulations.
N.B. The connection of the appliance to earth is mandatory.
If the installation requires alterations to the domestic electrical system call a qualified
electrician.
He should also check that the socket cable section is suitable for the power drawn by the
appliance.
Replacing the power cord must be done by a qualified electrician in accordance with
the instructions supplied by the manufacturer and in compliance with established
electrical regulations.