Kemppi DC 2000 - Manual (Page 23)

Mastertig aC/DC 000, 500, 500W, 3500W/0701 – 3 © keMppi oy
C 100C C 100D
C 100AC
6. accessories
6.1. reMote control units
C 100C Control of MMA / TIG welding current, memory scale 1 - 10.
C 100D Control and fine-tuning of MMA / TIG welding current, memory scale 1 - 10.
C 100AC Control of MMA / TIG welding current, memory scale 1 - 10 and MMA /
TIG selection.
C 100F Foot pedal control unit for TIG welding
– start function
– adjustment of the welding current with pedal movements
– limitation of the welding-current range with min and max potentiometers
6.1.1. Connecting the foot pedal unit:
The foot pedal unit has two connections, which are connected
to the remote control and start connections in the rear of the
power source. When using the foot pedal unit, the
maximum current output of the machine is ca. 30 %
below its maximum output unless the machine is calibrated for
the foot pedal unit.
6.1.2. Calibration of the machine for the foot pedal unit:
1. Turn the machine off.
2. Press the REMOTE key and at the same time turn the machine on; the display will show
the text rEn 01.
3. Turn the current adjustment knob so that the display will show rEn 02. (01=C 100C, 02=C 100F)
4. Press the REMOTE key so that the setting is saved in the memory.
6.2. Wheel barroWs anD transport chassises
T 120 (transport unit)
Mastertig AC/DC 2000, 2500, 2500W, 3500W
lifting ear
Do not lift the welding machine and
the transport unit with a gas bottle.
T 22 (transport unit)
Mastertig AC/DC
2500, 2500W, 3500W
lifting ears
on both sides
(total 4 pcs)