Kanguru U2D User Manual

Page 35

5.10 Most Var. Cap

The MOST VAR. CAP setting is specifically for the SMART function. In SMART mode, the system will

check the capacity of each connected Target drive. The MOST VAR. CAP setting defines the tolerance

range for different Target capacities. Tap the ‘RUN’ button to adjust the tolerance range.

• [0%] – All targets must be exactly the same capacity. Any Target that has capacity larger than the

smallest capacity Target will not be included when the SMART function is executed.

• [1-20%] – Any Target that has a capacity that is larger than the smallest capacity Target by the

percentage defined (3% by default) will not be included when the SMART function is executed.

5.11 Need Resize

The NEED RESIZE setting is specifically for the SMART function. In SMART mode, the system will

check the capacity between the Source and Targets. If the capacity between the Source and Target is

different, the NEED RESIZE setting will determine whether the system will run in Brief or Resize mode

when the SMART function is executed

• [0%] – If the capacity of the Targets is larger than the capacity of the Source then the system will

run in Resize mode when the SMART function is executed.

• [1-20%] – If the capacity difference between the Target and Source falls below the percentage

defined here (3% by default) then the system will run in Brief mode when the SMART function is

executed. If the capacity difference between the Target and Source exceeds the percentage defined

here then the system will run in Resize mode when the SMART function is executed.

Most Var. Cap / Need Resize