Kanguru U2D User Manual
Page 34
32
5.7 Skip Read Error
The SKIP READ ERROR option allows you to enable or disable error skipping during FULL, SMART,
BRIEF and RESIZE modes. Tap the ‘RUN’ button to change this option.
• [
٭
] – Enabled. When an error is detected while reading from the Source, the duplicator will skip
the bad sector on the Source and fill it with a zero on the Target.
• [ ] – Disabled (default). When an error is detected while reading from the Source, the duplicator
will cancel the current process.
5.8 Auto Run
The AUTO RUN option allows you to enable or disable whether the system will automatically execute
a function after 30 seconds. Tap the ‘RUN’ button to change this option.
• [
٭
] – Enabled. FULL, SMART, BRIEF, RESIZE, VERIFY, ERASE or LOAD modes will
automatically execute after 30 seconds.
• [ ] – Disabled (default). The user needs to manually start functions.
5.9 Load Full Image
The LOAD FULL IMAGE option allows you to control how device images are saved to a hard drive or
Storage Center. Tap the ‘RUN’ button to change this option.
• [
٭
] – Enabled. The system will not analyze the Source’s file system and will build the image
sector by sector.
• [ ] – Disabled (default). The system will analyze the Source’s file system before building the
image. If the Source’s file system is FAT/ NTFS/ EXT1/ 2/ 3/ 4, the image will be built based on
the file system and data area. Note: If the system cannot recognize the file system then the system
will automatically build a full image sector by sector.
Skip Read Error / Auto Run / Load Full Image