Kanguru U2D User Manual
Page 33
31
5.4 No Cap Check
The NO CAP CHECK option allows you to enable or disable whether the USB Duplicator checks the
capacity between the Source and Target(s). Tap the ‘RUN’ button to change this option.
• [
٭
] – Enabled. When the duplicator executes either a Disk Copy or Brief Copy, the Kanguru USB
Duplicator will not check the capacity between the Source and Target(s) and the copy process will
begin normally.
• [ ] – Disabled (default). When the duplicator executes either a Disk Copy or Brief Copy, the
Kanguru USB Duplicator checks the capacity between the Source and Target(s). If the capacity
between the Source and Target(s) is different, then the system will automatically cancel the copy
process.
5.5 Max UDMA Mode
The MAX UDMA MODE option allows you to configure the transfer speed specification for the Kanguru
USB Duplicator’s internal hard drive. Tap the ‘RUN’ button to change this option. The MAX UDMA
MODE can be set as 0 – 5. The MAX UDMA MODE is set to 4 by default.
5.6 Burn In
The BURN IN function allows the system to perform a Copy, Compare, Verify, Erase or Load function
continuously to stress test for endurance, reliability and stability.
To perform a continuous burn in test:
1. From the ADVANCED SETUP menu, tap the ‘SET’ button to navigate to the BURN IN option.
2. The BURN IN option is disabled by default. Tap the ‘RUN’ button to enable it.
3. Hold the ‘SET’ button to return to the SETUP menu.
4. From the SETUP menu, hold the ‘SET’ button to return to the Main menu.
5. Tap the ‘SET’ button to navigate to the mode that you want to test. The screen will display:
“READY TO BURN 30…”.
6. Tap the ‘RUN’ button to begin the burn in test, or wait for the “30” to count down to “0” and the
burn in test will start automatically.
7. Once the function has completed, The screen will display the total execution time, and then it will
once again display “READY TO BURN 30…”. When it counts down to zero the function will start
again. This will be repeated until you stop the burn in test.
8. To stop the burn in test, cancel a function while it is in progress by tapping either the ‘SET’ button
or ‘RUN’ button. This will automatically disable the burn in function and the USB Duplicator will
return to normal functionality.
No Cap Check / Max UDMA Mode / Burn In